Running-In; Overloading; Maintenance; Disposal - Dali SUB K-14 F Manuel

Les langues disponibles

5.4 poWer

The POWER switch is the main ON/OFF switch. We recommend switching 'OFF' the subwoofer

when it is not to be used for extended periods. When changing connections, always disconnect

the mains voltage from the subwoofer. We recommend that you ALWAYS turn 'OFF' the POWER

switch on the rear side of the subwoofer BEFORE turning off the mains switch.

5.5 on / StanD By moDe

The subwoofer has a built-in circuit that will power up the amplifier of the subwoofer when an

input signal is detected (given that the POWER is set to 'ON' and the POWER MODE switch is

set to 'AUTO'). When the subwoofer is 'ON', the ON/STANDBY LED will light up green. If an input

signal is not detected for approximately 20 minutes, the subwoofer will go into standby mode

and the ON/STANDBY LED will light up red.

6.0 RuNNING-IN

You should expect the sound quality from your new subwoofer to gradually improve during the

initial period of use. Nothing particular has to be done in order to run in the subwoofer – but

expect up to 100 hours of playback (depending on playback level) before full performance level

is reached. Use normal music for running-in the subwoofer.

If DALI SUB K-14 F is overloaded, the built-in safety circuit may power down the subwoofer.

The subwoofer will power on again when the temperature of the built-in amplifier is within safe

working range. If overloaded, we recommend that you turn off the subwoofer for a few minutes

before turning it on again.

note: The built-in safety circuit is no guarantee against damage as a result of overloading.

Cleaning the subwoofer surfaces can be done with ordinary household cleaning agents and

using a micro fibre cloth. Avoid using products that are abrasive or contains acid, alkali or anti-

bacterial agents. Avoid using aerosols. Avoid using cleaning agents directly on the drive unit

and clean it with extreme care.

8.1 aVoID DIrect SunLIGHt

The surfaces of the subwoofer may fade or become discoloured over time when exposed to

direct sunlight. Therefore avoid positioning the subwoofer in direct sunlight.

DALI products are designed to meet the international directives concerning Restriction of

Hazardous Substances (RoHS) and disposal of Waste Electrical and Electronic Equipment

(WEEE). The waste symbol indicates that the subwoofer meet the directives. The subwoofer

must be processed or recycled appropriately. Please consult your local waste authority for

guidance.

Table des Matières