Factory Reset; Sound Mode; Running-In; Overloading - Dali SUB M-10 D Manuel

ATTENTION! Keep the remote out of reach of children.
Display (see figure 6)
On the front of the subwoofer there is a translucent logo badge/display. the settings of the
subwoofer can be seen on the display when the subwoofer is operated by the remote control
or the buttons on the amplifier.

5.8 FACTORY RESET

to reset all memory settings to factory default, press the '+' and '-' buttons on the back of the
SuB M-10 D simultaneously for 10 seconds. this will set the values to:
VOLuME:
PHaSE:
crOSSOVEr:

SOuND MODE:

6.0 RUNNING-IN

You should expect the sound quality from your new subwoofer to gradually improve during the
initial period of use. Nothing particular has to be done in order to run in the subwoofer – but
expect up to 100 hours of playback (depending on playback level) before full performance level
is reached. use normal music for running-in the subwoofer.

7.0 OVERLOADING

If DaLI SuB M-10 D is overloaded, the built-in safety circuit will power down the subwoofer.
the subwoofer will power on again when the temperature of the built-in amplifier is within safe
working range. If overloaded, we recommend that you turn off the subwoofer for a few minutes
before turning it on again.
NOtE: the built-in safety circuit is no guarantee against damage as a result of overloading.

8.0 MAINTENANCE

cleaning the subwoofer surfaces can be done with ordinary household cleaning agents and
using a micro fibre cloth. avoid using products that are abrasive or contains acid, alkali or
antibacterial agents. avoid using aerosols. avoid using cleaning agents directly on the drive
units and clean them with extreme care.
8.1 AVOID DIRECT SUNLIGHT
the surfaces of the subwoofer may fade or become discoloured over time when exposed to
direct sunlight. therefore avoid positioning the subwoofer in direct sunlight.

9.0 DISPOSAL

DaLI products are designed to meet the international directives concerning restriction of
Hazardous Substances (roHS) and disposal of Waste Electrical and Electronic Equipment
(WEEE). the waste symbol indicates that the subwoofer meet the directives. the subwoofer
must be processed or recycled appropriately. Please consult your local waste authority for
guidance.
14
25
0
120
cINEMa