Klarstein 10027045 Mode D'emploi page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
Drain pump
doesn't stop
Noise
Suds in
the tub
Stained tub
interior
Dishes and
flatware
not clean
Spots and
filming on
glasses and
flatware
Cloudiness
on glassware
Yellow or brown
film on inside
surfaces
White film on
inside surface
The Detergent
dispenser lid
cannot be closed
Detergent left
in dispenser
cups
Steam
Black or
gray marks
on dishes
Water standing
on the bottom
Dishwasher
leaks
37
Possible causes
Overflow
Some audible sounds are
normal
Utensils are not secure in
the baskets/ something
has dropped into basket
Motor hums
Improper detergent
Spilled rinse agent
Detergent with
colorant was used
Improper program
Improper basket loading
1 Extremely hard water
2 Low temperature
3 Overloading
4 Improper loading
5 Damp powder detergent
6 Empty rinse agentr
7 Incorrect dosage
Combination of soft water
and too much detergent
Tea or coffee stains
Iron deposits
Hard water minerals
Clogged detergent residue
is blocking the catch
Dishes block
detergent Cups
Normal phenomenon
Aluminum utensils
have rubbed
against dishes
This is normal
Overfill dispenser or
rinse aid spills
Dishwasher isn't level
What to do
The system is designed to detect an overflow. When it does,
it shuts off the circulation pump and turns on the drain
pump.
Sound from detergent cup opening.
To ensure everything is secured in the dishwasher.
If you do not use it often, remember to set it to fill and
pump out every week, which will help keep the seal moist.
Use only the special dishwasher detergent to avoid
suds. If this occurs, open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to the tub. Close
and latch the dishwasher, then start the „pre-rinse" wash
cycle to drain out the water... Repeat if necessary.
Always wipe up rinse agent spills immediately.
Make sure that the detergent is the one without colorant
Select a stronger programme
Make sure that the action of the detergent dispenser and
spray arms are not blocked by large dishware
1 Take out all metal utensils out of the dishwasher.
2 Do not add detergent.
3 Choose the longest cycle.
4 Start the dishwasher and allow it to run for about 18 to 22
minutes, then it will be in the main wash.
5 Open the door to pour 2 cups of white vinegar into the
bottom of the dishwasher.
6 Close the door and let the dishwasher complete the cycle.
If the vinegar does not work use citric acid crystals instead.
Use less detergent if you have soft water and select a
shortest cycle to wash the glassware
Using a solution of 1/2 cup of bleach and 3 cups of
warm water to remove the stains by hand.
Call a water softener company for a special filter.
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves. Never
use any other cleaner than dishwasher detergent for the
risk of foaming or suds.
Clean the detergent from the catch.
Re-loading the dishes properly.
There is some steam coming through the vent by the
door latch during drying and water draining.
Use a mild abrasive cleaner to eliminate those marks
A small amount of clean water around the outlet on
the tub bottom keeps the water seal lubricated.
Be careful not to overfill the rinse aid dispenser.
Spilled rinse aid could cause oversudsing and lead
to overflowing. Wipe away any spills with a damp cloth.
Make sure the dishwasher is level.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1002864210027046

Table des Matières