Klarstein 10027045 Mode D'emploi page 27

Fill the rinse aid dispenser
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, spot and streak
free drying.
WARNING
Only use branded rinse aid for dishwasher. Never fi ll the rinse aid dispenser with any other
substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the ap-
pliance.
If there is no rinse-aid warning light on the control panel, you can judge
the amount of rinse-aid by the color of the optical level indicator „D"
located next to the cap. When the rinse-aid container is full, the whole
indicator will be dark .As the rinse aid diminishes, the size of the dark
dot decreases. You should never let the rinse aid get below 1/4 full.
How to fi ll the rinse aid dispenser
1. To open the dispenser, turn the cap to the „open" (left) arrow and lift it out.
2. Pour the rinse aid into the dispenser, be careful not to overfi ll.
3. Replace the cap by inserting it aligned with „open" arrow and turning it to the „closed" (right)
arrow.
The rinse aid is released during the fi nal rinse to prevent water from forming droplets on your dishes
that can leave spots and streaks. It also improves drying by allowing water to sheet off the dishes.
Your dishwashers are designed to use liquid rinse aids. The rinse aid dispenser is located inside the
door next to the detergent dispenser. To fi ll the dispenser, open the cap and pour the rinse aid into
the dispenser until the level indicator turns completely black. The volume of the rinse aid container
is about 140ml. Be careful not to overfi ll the dispenser, because this could cause over sudsing. Wipe
away any spills with a damp cloth. Don't forget to replace the cap before you close dishwasher door.
ATTENTION
Clean up any rinse aid split during fi lling with an absorbent cloth to avoid excess foaming
during the next wash.
How to adjust the rinse aid dispenser
The rinse aid dispenser has four or six settings. Always start with the dispenser
set on „4" If spots and poor drying are problems, increase the amount of rinse
aid dispensed by removing the dispenser lid and rotating the dial to „5 . If the
dishes still are not drying properly or are spotted, adjust the dial to the next
higher number until your dishes are spot-free. The dose is factory set in
position 5. Increase the dose if there are drops of water or lime spots on the
dishes after washing. Reduce it if there are sticky whitish streaks on the dishes
or a bluish fi lm on glassware or knife blades.
27