ENGLISH
4
Introduction
Full-body tanner
With this tanning appliance you can suntan comfortably at home.The tanning lamps emit visible light, heat and ultraviolet light, giving you the
impression you are sunbathing in real sunlight.The special UV filter only passes the light that is required to get a tan.
The tanning lamps emit sufficient infrared light to provide a comfortable warmth.
Type HB975 only: besides a tanning session, you can take a relax session by just switching on the special infrared lamps.
A timer ensures that each session does not last longer than 30 minutes. Just as with natural sunlight, overexposure must be avoided (see section
'Tanning and your health' and 'Relaxation and your health').
General description (fig. 1)
A
Height adjustment knob
B
Unlocking button
C
4 Tanning lamps Philips HPA flexpower 400-600
D
2 Infrared lamps type IRK 15020 R (1500W) or 4222 062 95600 (1100W) (HB975 only)
E
Stand
F
Protective goggles (2 pairs)
-
(type no. HB072/service no. 4822 690 80147)
G
Lock slide
H
Handgrip
I
Storage compartments for the cord and remote control.
Important
Read these instructions for use carefully before using the appliance and save them for future reference.
Check if the voltage indicated on the appliance corresponds to the mains voltage in your home before you connect the appliance.
If the plug has not been inserted properly into the wall socket, it may become hot. Make sure you insert the plug properly into the wall
socket.
The appliance must be connected to a circuit that is protected with a 16A (10A for Switzerland and Scandinavian countries) standard fuse
or an automatic fuse.
Always unplug the appliance after use.
If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips in order to
avoid hazardous situations.
Water and electricity are a dangerous combination! Do not use this appliance in wet surroundings (e.g. in the bathroom or near a shower or
swimming pool).
If you have just been swimming or have just taken a shower, dry yourself thoroughly before using the appliance.
Let the appliance cool down after use for approx. 15 minutes before folding it back into transport position and storing it.
Make sure the vents in the centre and side lamp units and in the base remain open during use.
The appliance has been fitted with an automatic protection against overheating. If the appliance is insufficiently cooled (e.g. because the vents
are covered), the appliance will switch off automatically. Once the cause of overheating has been removed and the appliance has cooled
down, the appliance can be switched on again.
The UV filters become very hot when you use the appliance. Do not touch them.
The appliance contains hinging parts, so be careful not to get your fingers stuck between the parts.
The rubber parts fitted onto the appliance may give off a slight smell the first times you use the appliance.This is not an assembly fault.This
smell will disappear after a few sessions.
Never use the appliance when a UV filter is damaged, broken or missing.
Never use the appliance when the remote control is defective.
Make sure children do not play with the appliance.
Do not exceed the recommended session time or the maximum number of tanning hours (see 'Tanning sessions: how often and how long?').
Do not take a tanning and/or relax session if you have a disease and/or if you use a medication or cosmetics that increase the sensitivity of
your skin. Be extra careful if you are hypersensitive to UV light or IR light. Consult your doctor in case of doubt.
Do not tan a particular part of your body more than once a day. Avoid excessive exposure to natural sunlight on the same day.
Consult your doctor if ulcers, moles or persistent lumps develop on the skin.
The appliance is not to be used by people who get sunburnt without tanning when exposed to the sun, by persons suffering from sunburn,
by children, or by persons who suffer (or have previously suffered) from skin cancer or who are predisposed to skin cancer.
Always wear the protective goggles provided with the appliance while tanning to protect your eyes from excessive doses of visible light, UV
light and IR light (also see section 'Tanning and your health').
Remove creams, lipstick and other cosmetics well in advance of a tanning session.
Do not use any sunscreens or suntan accelerators.
If your skin should feel taut after the tanning session, you may apply a moisturising cream.
To acquire an even tan you should lie directly below the lamp units.
Do not choose a tanning distance of less than 65 cm.
Only move the appliance when it is in transport position. Make sure that the two parts of the appliance have been properly fastened before
you move it. Do not attempt to lift the appliance on your own.
Colours may fade under the influence of the sun.The same effect may occur when you use this appliance.
Do not expect the appliance to yield better results than the natural sun.
Tanning and your health
The sun, UV and tanning
The sun
The sun supplies various types of energy.Visible light enables us to see, ultraviolet (UV) light gives us a tan and the infrared (IR) light in sunlight
provides the heat in which we like to bask.