RODE NT-USB Mode D'emploi page 5

Mounting the NT-USB
8
The NT-USB is supplied with
a high quality tripod mount.
To assemble simply screw the
mounting ring onto the tripod
stand (diagram 1). The mounting
ring can also be used as a mic
clip to attach the NT-USB to a
mic or boom stand.
To install the NT-USB in the
mounting ring place the micro-
phone in the mount from above
(optionally using the pop filter),
and thread into the mounting
ring. Once the microphone is
facing the correct way, turn the
dial at the bottom clockwise until
tight (diagram 1).
Diagram 1 - Mounting the NT-USB
in the supplied tripod stand
To change the microphone
position, always be sure to
loosen the adjustment lever to
ensure that you do not damage
the stand.
When recording vocals,
always use the supplied pop
filter, mounted in front of the
microphone. The pop filter will
prevent plosives (hard 'P', 'B', 'T'
and 'K' sounds) from overloading
the microphone's capsule.
9
Diagram 2 - Adjusting the
microphone position