Alcad 912-TP Série Manuel D'installation Et Programmation page 42

A. The INPUT satellite transponder hook-up indicator (22) does not turn on.
C. The programmed QPSK signal data are incorrect.
S. Check the programmed values of the symbol rate (S/R), FEC and type
of QPSK signal spectrum. These data can be found in the lists of satellite
programs and the type of spectrum can be programmed automatically
by selecting
A. The 'correct MPEG transmodulation' indicator (28) does not turn on.
C. The MPEG transmodulation stage does not receive any QPSK signal.
S. Make sure the satellite transponder hook-up indicator is on.
A. The HF output channel indicator (29) does not turn on.
C. The IF-to-channel converter does not work properly.
S. Check the transmodulator supply voltages.
A. Picture is black and the QPSK and MPEG les are on.
C. Emission of that channel might have finished (some channels do not
broadcast 24 hours a day) or the list of programs might have been
changed.
S. Change to OSD mode and retune the transponder.
A. The screen shows the message Please, insert your card in a
conditional access module
C. The CAM card doesn't exist or it is wrong.
S. Insert o replace a suitable card with your platform.
A. Black screen in a conditional access module.
C. The CAM module doesn't exist or it is wrong.
S. Insert o replace the CAM module together with a suitable CAM card with
your platform
A. The picture is frozen, the INPUT indicator is switched off and the MPEG
indicator is blinking
C. There is no satellite signal at the transmodulator input
S. Please check the feeding of the LNB (21) and the input signal at the output
of the last module (20).
A. The screen shows the message No right to watch this program
in a conditional access module
C. A platform TV card is already installed, but you haven't subscribed this
program
S. Please contact with the TV platform in order to subscribe to this program
Serie 912-TP
.
Auto
ENG - 41