Siemens VS08 Notice D'utilisation page 39

en
Changing the micro-hygiene filter*
The micro-hygiene filter should be replaced with every new
replacement filter pack (after 4 dust bags) and at least
once a year.
21
Figure
Press the locking tab in the direction of the arrow to
unlatch the exhaust grille and open it.
Unlatch and remove the filter frame by pressing the tab
in the direction of the arrow.
22*
Figure
Remove the foam and micro-hygiene filter.
Dispose of the micro-hygiene filter and fit a new micro-
hygiene filter.
Clean the foam and replace in the filter frame.
If you have used the vacuum cleaner for fine dust particles
(such as plaster or cement), clean the motor protection fil-
ter by tapping it and, if necessary, replace the motor protec-
tion filter and the micro-hygiene filter.
23
Figure
Slide the filter frame under the two retaining ribs and push
in the direction of the arrow until it engages.
Close the exhaust grille.
Replacing the Hepa filter*
If your vacuum cleaner is fitted with a HEPA filter,
this must be replaced once a year. (See figures 21 and 23 for
changing the filter)
Replacing the active carbon filter*
If your vacuum cleaner is fitted with an active carbon filter, this
must be replaced once a year.
24*
Figure
Remove the active carbon filter and dispose of it with
the household rubbish.
Insert a new active carbon filter. (See Figures 21, 22, 23
for changing the filters)
* Dependent on model
38
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the appliance.
The vacuum cleaner and plastic accessories can be cleaned
with a commercial plastic cleaner.
!
Do not use a scourer, glass-cleaning agent or all-pur-
pose cleaning product.
Never immerse the vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a dry cloth or
dusting brush.
Subject to technical modifications.