General And Specific Safety Rules; Work Area; Electrical Safety; Personal Safety - Enarco VGR6 Manuel D'instructions

3

GENERAL AND SPECIFIC SAFETY RULES

WARNING!

3.1 WORK AREA

KEEP your work area clean and well lit. Cluttered benches and dark areas invite accidents.
DO NOT OPERATE power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes.
KEEP bystanders, children, and visitors away while operating a power tool.

3.2 ELECTRICAL SAFETY

GROUNDED TOOLS MUST BE PLUGGED INTO an outlet properly installed and grounded in
accordance with all codes and ordinances.
NEVER REMOVE the grounding prong or modify the plug in any away.
DO NOT USE any adaptor plugs.
CHECK with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. If
the tools should electrically malfunction or break down, grounding provides a low resistance path to
carry electricity away from the user.
AVOID body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your body is grounded.
DON'T EXPOSE power tools to rain or wet conditions. Water entering a power tool will increase the
risk of electric shock.
DO NOT ABUSE the cord.
NEVER USE the cord to carry the tool.
en
NEVER PULL the plug from an outlet.
KEEP cord away from heat, oil, sharp edges or moving parts.
REPLACE damaged cords immediately. Damaged cords increase the risk of electric shock.
WHEN OPERATING a power tool outside, use an outdoor extension cord marked "W-A" or "W".
These cords are rated for outdoor use and reduce the risk of electric shock.

3.3 PERSONAL SAFETY

STAY ALERT, watch what you are doing and use common sense when operating a power tool.
DO NOT USE TOOL while tired or under the influence of drugs, alcohol, or medication. A moment of
inattention while operating power tools may result in serious personal injury.
DRESS PROPERLY.
DO NOT WEAR loose clothing or jewellery.
CONTAIN long hair.
KEEP your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery, or long hair
can be caught in moving parts.
AVOID accidental starting.
BE SURE switch is off before plugging in. Carrying tools with your finger on the switch or plugging in
tools that have the switch on invites accidents.
REMOVE adjusting keys or switches before turning the tool on. A wrench or a key that is left
attached to a rotating part of the tool may result in personal injury.
DO NOT overreach.
KEEP proper footing and balance at all times. Proper footing and balance enables better control of
the tool in unexpected situations.
USE safety equipment.
Always WEAR eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing protection
must be used for appropriate conditions.
PETROL ENGINE-ELECTRIC MOTOR-FLEXIBLE SHAFT AND POKERS
6
VGR6, VGH5, VGE5, VYD, VHD, VLD - VPA, VPAME - TNR - ANR
Read and understand all instructions.