Full Extension Drawers; Insert Wine Bottles - Cafe CCP06DP Serie Manuel D'utilisation Et D'installation

Using the Wine Center

FULL EXTENSION DRAWERS

All of the full extension drawers pull out so bottles can be
conveniently added or removed.
Any of the full extension drawers can be removed to
store larger bottles.
To remove:
1. Pull the full extension drawer out to the STOP position.
2. Push the tab on right drawer guide down while pulling
the tab on left guide up, and pull the drawer out.

INSERT WINE BOTTLES

The top five full extension drawers each hold eight
bottles, two deep with the necks alternating front to back.
The top shelf in each zone can store larger bottles by
orienting them sideways. The other full depth shelves
can hold 7 bottles in the sideways orientation. This
orientation provides additional length that may be
needed for some bottle shapes.
8 bottle arrangement
7 bottle arrangement
8
To replace:
1. Push the drawer slide arm back
2. Pull the small slide sub-
3. Insert the sides of the drawer
4. Push until the tabs lock into
NOTE: Make sure the tabs on
the full extension drawer guides
are fully engaged before loading
Tab (push tab down
any bottles. Pull the drawers out
on right drawer
all the way to the STOP position
guide, pull tab up on
left drawer guide)
and push back in several times
to make sure locking tabs are
properly engaged.
The bottom full extension drawer holds six bottles and is
loaded with necks facing the rear.
Large bottle arrangement -
top shelf of both zones
into the unit.
assembly completely forward.
back into the guides.
place.
Appearance may vary
Sub-assembly
To replace, push drawer
slide arm back into unit
Sub-assembly
Pull small slide sub-
assembly completely
forward
Bottom drawer
49-1000492 Rev. 3