Installation Instructions - Cafe CCP06DP Serie Manuel D'utilisation Et D'installation

Installation
Instructions
Questions? Visit our Website at: cafeappliances.com
In Canada, visit cafeappliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
•
and ordinances. Save these instructions for local
inspector's use.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Wine center Installation
can vary
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING
EXCESS WEIGHT HAZARD
Use two or more people to move and install wine
center. Failure to do so can result in back or other
injury.
IMPORTANT: Handle with care when moving wine
center to avoid either damaging the refrigerant tubing or
increasing the risk of a leak.
IMPORTANT: If the wine center has been placed in a
horizontal position for any period of time, wait one hour
before plugging in to allow the refrigerant to settle.
10
—
Observe all governing codes
Wine Center
LOCATION REQUIREMENTS
IMPORTANT: Before use, this wine center must be
installed properly.
NOTE: Allow the wine center to sit upright on its base
for at least one hour before installation.
• Do not install the wine center where the
temperature will go below 55°F (13°C) because
it will not run often enough to maintain proper
temperatures.
• Do not install the wine center where the
temperature will go above 110°F (43°C) because it
will not perform properly.
• Install it on a floor strong enough to support it fully
loaded.
• Do not install the wine center in a location exposed
to water (rain, etc.) or direct sunlight.
TOOLS NEEDED
• Phillips Screwdriver
• Measuring Tape
• Carpenter's Level
• Flathead screwdriver
PARTS SUPPLIED
Anti-tip Brackets (Qty 4)
Toe Kick Brackets (Qty 2)
Protective Guard (Qty 1)
Toe Kick (Qty 1)
Handle (Qty 1)
1/8" Allen Wrench (Qty 1)
Screws
Screw A Screw B Screw C
- Qty 4 - Qty 6
Screw D Screw E
- Qty 4 - Qty 4 - Qty 2
49-1000492 Rev. 3