Door Adjustment; Handle Installation - Cafe CCP06DP Serie Manuel D'utilisation Et D'installation

Installation Instructions
INSTALLING THE WINE CENTER (Cont.)

DOOR ADJUSTMENT

1. Peel back the gasket near the hinge
Gasket
2. Use a flat screwdriver to remove the plastic cover.
3. Loosen the screws to make the adjustment and the
tighten the screw. NOTE: Push door in direction of
arrow to raise handle side of door.r
4. Re-install the plastic cover and gasket. Make sure
that gasket is fully seated in the pocket.
14
Remove all protective film from the door before
installing the handle.

HANDLE INSTALLATION

1. Remove the handle allen wrench from the
accessory bag located inside the wine center.
2. Remove the handles from the top piece of the
packaging material.
3. Loosen the set screw using the allen wrench.
set screw
LOOSEN
set screw set screw
LOOSEN
LOOSEN
Place the handle caps over the fasteners of the
door, so that the Cafe badge is at the top of the
handle. Take care to support the handle so it doesn't
fall and scratch the appliance finish. Make sure both
handle caps are resting on the face of the door.
fastener
fastener fastener
4. Lock one end of the handle into position by
tightening the set screw in the handle cap with the
allen wrench provided. DO NOT over-tighten.
set screw
set screw set screw
5. K eep supporting the handle as you lock the other
end of the handle into position by tightening the set
screw in the handle cap. DO NOT over-tighten.
set screw
set screw set screw
handle cap
handle cap handle cap
set screw
set screw
set screw
49-1000492 Rev. 3