Controls - GE UVW9301 Manuel D'utilisation Et Instructions D'installation

Controls

1
2 3
1. Rangehood Control Panel:
panel is located on the front of the canopy. The
position and function of each control pad are
noted below.
2. On/Off:
On/Off switch for the fan and lighting up
the display. The fan can be operated by tapping
any of the fan setting pads. Hold On/Off pad for
3 seconds to activate Delay Off feature, which
automatically turns the fan off after 15 minutes.
3. Fan Setting:
Speed control for fan. Tap Low
for LOW speed. Med for MEDIUM speed and High
for HIGH speed. Press and hold the High pad
for 3 seconds to activate the BOOST speed that
will run for 10 minutes. On Remote, press
increase fan speed, press
including Boost.
4. Plus and Minus:
pads control the time for the clock and the timer.
To add time, tap the + pad. To subtract time, tap
the – pad.
5. Timer:
Sets a timer for cooking or sets the clock.
To start the timer, tap the Timer pad and the clock
will show "HR" and "MIN". Tap + or – to add or
subtract time. Tap on the Timer again to start the
countdown. To cancel the timer, tap the Timer pad
again. Hold the Timer pad down for 3 seconds to
set the clock. Tap the + or – to set the the hour.
Tap on the Timer again to set minutes. Tap on the
Timer again to lock in the time. Clock will sync once
the unit is connected to Wi-Fi.
49-2000896 Rev. 0
4 5
The control
to
to decrease fan speed,
The plus (+) and minus (–)
9
3
10
6 7 8
6. Light:
Controls the lights. Tap the Light pad to
turn the lights on fully. Tap the Light pad again and
the lights will dim. Tap the Light pad a third time to
turn off the lights.
7. Chef Connect:
down for 3 seconds to activate the Bluetooth
is a Bluetooth ® pairing feature for use with other
compatible Chef Connect enabled products on a
cooktop or range. When the device is paired, the light
and fan will turn ON at the Default Sync Settings upon
receiving a command from the range or cooktop. It
will remain ON at that setting until the user changes
it. See the Chef Connect section for more details.
8. Reset Filter:
The red LED indicator above the
Reset Filter pad turns on as a reminder to change
/clean the filter. Hold the Reset Filter pad for 3
seconds to turn off. Tap the Reset Filter pad again
to begin recalculating the time. While this indicator
reminds user to change/clean filters, the filters
should be cleaned regularly. Please refer to the
Filters section.
9. Wi-Fi:
Hold down the Light and Chef Connect
pads for three seconds to activate the Wi-Fi connect
mode. The Wi-Fi symbol above the clock blinks for
3 seconds and then becomes solid. See the Wi-Fi
section for more details. On Remote, press Wi-Fi to
toggle Wi-Fi function.
10.
Delay Off (Remote only):
Delay Off to toggle Delay Off function.
2
6
9
7
Remote Control
Hold the Chef Connect pad
® . This
Press and hold
5