GAPOSA QC09 Mode D'emploi page 8

PROGRAM OTHER TRANSMITTERS
1. Press and hold PROG-TX button of the MASTER transmitter till the motor starts moving.
The motor is now in programming mode.
2. Press and hold PROG-TX button of the MASTER transmitter till the motor starts moving. The motor is
now in programming mode.
1
MASTER
PROG-TX
RESET MEMORY
To cancel transmitters from the motor's memory, press PROG-TX and STOP buttons of the MASTER
transmitter simultaneously and release them when the motor jogs indicating that any transmitter is
cancelled.
STOP
PROG-TX
PROG-TX
RESET MEMORY WITHOUT THE MASTER TRANSMITTER
To cancel programmed transmitters without the MASTER:
1. Cut the power
2. Press simultaneously PROG-TX and STOP buttons of whatever transmitter and switch on the power
till the motor jogs indicating that any transmitter is cancelled.
2
STOP
PROG-TX
PROG-TX
8
QC 09
Remote Control Unit for shutters and awnings.
2a
STOP
STOP
2b
UP
ON
DOWN