Troubleshooting - Insignia NS-A2110 Guide De L'utilisateur

To repeat an entire program:
1 Press REPEAT twice while the program is playing.
2 To cancel repeat, press REPEAT again.

Troubleshooting

Caution
Problem
No sound or
power
The CD does
not play
No disc
indicated on the
display
No sound in the
headphones.
The CD skips
during play.
12
Do not try to repair the shelf system yourself. Doing so will
invalidate your warranty.
Possible cause
Volume too low.
AC power cord not securely
connected.
The CD was incorrectly
inserted.
The CD is defective.
The CD compartment is not
closed.
There is condensation in the
CD compartment.
No CD inserted.
The CD is badly scratched or
dirty.
There is condensation in the
CD compartment.
You are using a CD-R or
CD-RW that is blank or the
disc has not been finalized.
The headphone jack is not
correctly inserted.
The volume control is turned
down.
The CD is defective.
The CD or lens is dirty.
Strong shaking or vibrations
The CD player is programmed
to skip a track.
www.insignia-products.com
Insignia NS-A2110 Executive Shelf System
Solution
Turn up the volume.
Connect the AC power cord.
Reinsert the CD, label side up.
Try another CD.
Close the CD door.
Remove the CD and leave the
cover open for about an hour in a
dry environment.
Insert a CD, CD-R, or CD-RW disc.
Clean the CD if it's dirty. Replace
the CD if it's defective.
Remove the CD and leave the
cover open for about an hour in a
dry environment.
Use a finalized CD-R or CD-RW.
Reinsert the headphone plug into
the jack.
Increase the volume.
Try another CD.
Clean or replace the CD, or clean
the lens.
Place the shelf system on a flat and
stable surface without vibration.
Quit the Program mode.