Start-Up; Application - WAGNER FURNO F100 Traduction Du Mode D'emploi Original

GB

6. Start-up

Before connecting to the mains supply, be sure that the supply voltage is identical with
the value given on the rating plate.
1. Plug the Heat Gun into a standard socket-outlet.
2. Turn on the Heat Gun by moving the switch to the desired setting. The motor-
driven fan noise will indicate that the Heat Gun is running.
Caution: If the fan does not switch on, switch the heat gun off immediately (position
0). Without cooling from the fan, the heating element will burn out.
Smoke may appear during the first start up due to the burning of
i
manufacturing oils. The smoke should disperse shortly after first start up.

7. Application

Always read the safety information included in this manual before
using the Heat Gun.
The recommended temperature settings for individual applications can be
i
found in the table in Section 8.
Hands-free operation
Press the clip together and turn it backwards in Press the clip together and turn it backwards in
order to be able to park the heat gun upright. order to be able to park the heat gun upright.
Stripping Paint
Always protect glass when working near windows.
Do not use the Heat Gun on surfaces that can be damaged by heat, such
as vinyl-coated paneling, vinyl-coated siding or vinyl-coated window
frames.
When removing paint from window frames, the Heat Gun will soften
the putty. Be careful not to gouge the putty with the scraper. The putty
will firm up after it cools.
Do not use the Heat Gun on insulating laminated window glass such as
Thermopane. The glass edge expansion may break the edge seal.
14
Furno F100