Tools Required - nVent RAYCHEM Elexant 9200i Mode D'emploi

TOOLS REQUIRED

Small flat-blade screwdriver (terminal driver), wire strippers and utility knife, and/or wire cutters.
SUPPORTING INFORMATION
Further information pertaining to transceiver hardware and software can be found within associated manufacturer's
documentation.
APPROVALS
Areas of Use
Approvals (applicable to Enclosures)
RAYCHEM-IM-H60818-Elexant9200i-ML-2009
DESCRIPTION
The nVent RAYCHEM Elexant 9200i is a Wireless
Communications Interface that provides an alternative solution
to hardwired Remote Monitoring and Configuration of Electric
Heat Tracing (EHT) systems. It integrates with nVent RAYCHEM
Supervisor software and Electric Heat Trace (EHT) controllers,
helping reduce TIC/TOC of a project.
The Elexant 9200i product line consists of the following:
• Standalone enclosures
• A wireless communications option within a given
Control Panel
• External antenna packages
A minimum of two radio transceivers are required to establish
a network. Standalone enclosures can be configured in many
ways, enabling the customer to choose from a range of options:
enclosure material, radio frequency, and antenna type.
Class I, Division 2 / Zone 2 Hazardous locations
Hazardous Locations
Class I, Division 2, Group A,B,C,D T4
Class I, Zone 2, IIC T4
Type 4X
IP64 (FW), IP66 (SW)
E490519
Proc. Cont. Eq.
For Haz.Loc
DEMKO 20 ATEX 2376 X
II 3G Ex ec IIC T4 Gc IP64 (FW), IP66 (SW)
IECEx UL 20.0056 X Ex ec IIC T4 Gc IP64 (FW), IP66 (SW)
nVent.com/RAYCHEM | 2