Cleaning The Juicer; Troubleshooting Guide - Hamilton Beach Commercial 96700 Manuel D'utilisation

Cleaning the Juicer

wWARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts before operating.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Partial Cleaning
The juicer should be cleaned frequently between
operations. Do not allow juice to dry on juicer
parts. To give the juicer a partial cleaning:
1. Unplug the juicer.
2. Remove all pulp and seeds from the reamer,
strainer, and stainless steel bowl.
3. Wipe all parts with a clean damp cloth.
Full Cleaning
1. Unplug the juicer.
2. Remove the following parts from base:
• Remove the splash cover, reamer, strainer,
and bowl.
3. Remove all pulp and seeds from the removed
parts.

Troubleshooting Guide

Problem . . .
Juice will not flow through
container spout
Juicer will not ream fruit
Motor will not run
Juice has bitter taste;
rind in juice
6
Solution . . .
• Check to see if the strainer or spout is plugged with seeds or pulp from
the last use.
• Make sure enough pressure is applied to the fruit during operation.
• Make sure the reamer is pushed all the way down onto the motor shaft.
• Motor has stalled and/or motor cutout switch has opened. Unplug the
juicer and allow the unit to cool.
• Make sure excessive pressure is not applied to fruit during operation.
• Make sure juicer is securely plugged into outlet and power switch is fully
depressed in the On position.
• Make sure excessive pressure is not applied to fruit during operation.
4. All the removed parts may be washed in a com-
mercial dishwasher or hand washed using warm
water (120 °F) and liquid detergent.
5. Wipe the base, motor shaft, and splash cover
with a clean, soft cloth and a mild, non-abrasive
detergent.
NOTE: Do not wash the base in a sink, or spray
water on it.
6. Reassemble the juicer in the reverse order.
Splash
cover
Reamers
Strainer
Stainless
steel bowl
Spout
Motor
shaft