Use - Prodipe M850 DSP Solo Manuel Utilisateur

6 – Use
Three positions switch attenuator (BODYPACK B210 ONLY)
The bodypack B210 is equipped with a three-position switch to adapt as best as possible the
sensitivity of the microphone, or active guitar cable, with an optimal volume of the UHF signal:
(0dB / -10dB / -20dB)
Connector adapter (BODYPACK B210 ONLY)
To be able to use a maximum of microphone and actif cable on the mini-XLR input of the bodypack
B210, an A / B switch has been added to compensate the different connectors used.
If you are using a Prodipe Lavalier tie-clip microphone, refer to the accompanying user manual for the
If you are using microphones from the Prodipe 21 Series, refer to the accompanying user manuals for
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2019 IPE Music/Prodipe
For better sound capture and a perceptible volume
increase with your M850 microphone, point the head
towards the sound source and keep it away from
Do not cover any part of the wire mesh with your
hands. Covering the mesh alters the sound and
distorts the polarity, increasing the risk of feedback.
To avoid this problem, first lower the microphone
volume, then hold it a little further away from the
speaker or singer's mouth.
The headset microphone, which can be used with the
B210 Bodypack, should be positioned as close as
possible to the mouth but off the direct axis, to
suppress plosive sounds in speech.
best position.
the best position.
undesired sounds.
Page 21