Receiver Functions And Features; Rear Panel - Prodipe M850 DSP Solo Manuel Utilisateur

3 – Receiver functions and features
1.
1. "POWER" supply button: off/on.
2. Configuration "SET" button: receiver menu.
3. "UP" button: switch to next higher channel.
4. "DOWN" button: switch to next lower channel.
5. Reception and cell tell-tale light [IR].
6. LCD display.
7. Audio output volume control(s).
2.
Balanced mono audio output XLR (track B on Duo versions).
1.
2. MIX OUT (tracks A+B) unbalanced mono audio output 6.35mm jack (Duo versions).
Unbalanced mono audio output 6.35mm jack (Solo versions).
3. Balanced mono audio output XLR (track A on Duo versions).
Balanced mono audio output XLR (main track on Solo versions).
Power supply connection (12-18V DC).
4.
5. BNC antenna output (channel A on the Duo version) (single on Solo version).
6. BNC antenna output (channel B on the Duo version).
Note:
For M850 Duo and B210 Duo receivers, you must respect the antenna frequencies on each BNC
output, the 630-650MHz antenna on channel A and the 650-680MHz antenna on channel B.
The inversion of these antennas can limit the range of your UHF.
Illustrations et photos non contractuelles
Actual product(s) may differ from illustrations/photographs used
Copyright © 2019 IPE Music/Prodipe
Front panel:

Rear panel

Page 17