auna 10005774 Mode D'emploi page 14

Pairing the headset with Bluetooth devices
How to enter pairing mode
Function
Enter pairing mode
NOTE: The pairing mode will last 2 minutes, If the headset still can't pair with any Bluetooth devices
after 2 minutes, it will switch into standby mode automatically.
Pairing the headset with Bluetooth mobile phone
Please make sure your mobile phone has Bluetooth function that can be used. Specific pairing pro-
cedures may vary with different mobile phone. Please refer to your mobile phone manual for further
information. Steps as follows:
1 Please keep the headset and mobile phone in the range of 1 meter when pairing.
2 Make the headset enter into pairing mode (Please refer to "how to enter into pairing mode").
3 Start the Bluetooth function of mobile phone and search the Bluetooth devices. After searched,
select "Auna Bluetooth"in the Bluetooth device list.
4 According to indication, enter password or PIN No:"0000",and press the key of" Yes" or "confir- med".
5 After successful pairing, select "Auna Bluetooth" in the Bluetooth device list, and press "connect".
6 After successful connecting, the blue LED of the headset quickly blinks twice or three times every
4 seconds.
NOTE: If the pairing is not successful, please switch off headset firstly, and then re-pair according to the
step 1 6 mentioned above. After pairing is successful, paired devices will remember each other. Unless
pairing information is deleted because of new pairing, no need to pair when use next time. The headset
can remember 8 paired devices, when paired devices exceed 8 paired devices, the first one will be re-
placed. If you want to pair the headset with other devices, please pair it with the new device according
to steps 1 6 mentioned above.
14
Operation
Make sure the headset is off. Press and hold MFB
button for 7-9 se- conds, and release it till the red
and blue LEDS blink al- ternately
LED Indication
indicator tone
Red and Two "DU"
blue LEDs tones
blink alter-
nately.