Use And Operation - auna 10005774 Mode D'emploi

Before you use this Bluetooth headset, please charge its battery of fully. Then every next time: When you hear
three warning tones of "DONG" every 20 seconds, at the same time, the red light blinks two times. It means the
battery is low power and need to be charged. There are two types of charging as below:
Charging the battery with travel charger
1 Plug the travel charger into standard AC power outlet.
2 Connect the travel charger with the charging port of the headset. When the red light is on, the
headset is charging.
3 When the red light is off, the headset is charged fully. It takes about 3 hours to charge the headset
fully.
Charging the battery with USB cable
1 Insert USB charging cable into USB port of PC.
2 Connect charging cable with the charging port of headset. When the red light is on, the headset is
charging.
3 When the red light is off, the headset is charged fully. It takes about 3 hours to charge the headset
fully.
NOTE: Choosing travel charger or USB cable depends on different countries or areas and actual demands.
Switching on/off
Function Operation
Switch on Press the MFB button for
3-5 se- conds, and release
it till the blue LED is on
Switch off Press the MFB button for
3-5 se- conds, and release
it till the red LED is on
NOTE: In order to save power, the headset will automatically switch off if no devices can be connected
within 5 minutes after switching on

Use and Operation

LED indicator
Blue LED is on for 1 second A long "DI" tone
Red LED is on for 1 second
Indication tone
A long "DI" tone
13