Installation; Introduction; Items Supplied; Special Recommendations For Installation - ENAG CDTV-400-50-24-40 Mode D'emploi

Installation

3.1 Introduction

This section deals with matters relating to charger installation.
Installation and operating the charger for the first time must be undertaken by an
electrician or professional installer in accordance with the standards in force
(ex : in the case of pleasure boats, comply with the international standard ISO 13297).
The installer must take note of this operating manual and must inform users of the matters
relating to installation and safety contained in section 5.
The equipment must be installed according to the recommendations of the user manual.
The main rules are as follows:
Use shielded cables with a correct section in order to power the appliance and the load
centres within acceptable tolerance limits.
(Definition criteria: nature and length of the cables, ambient temperature, voltage
drop, type of tracking, etc.).
Make sure the equipment is correctly ventilated for good heat dissipation (installation
space, ambient temperature, etc.).
Choose the location in accordance with the protection rating of the appliance.
The cases or cabinets for the appliances or containing the equipment must be metallic
or have a conductive coating.
The ground bolt or lug of the casing should be connected to the main ground by the
shortest strap possible. The bolt connected to the main ground must have a good
electrical contact (scratch off the paint and weld the bolt).
The ground being the reference point of the potential, the various current-bearing
parts of the equipment environment must be made equipotential by linking them
together (where possible, metal shielding and troughs are grounded with the shortest
straps).

3.2 Items supplied

ENAG supply items include the following elements:
1 metal case containing the battery charger electronic functions,
the present documentation (operating manual).

3.3 Special recommendations for installation

3.3.1. Case position

3.3.1.1. Preventing the charger overheating
The charger is designed to be mounted on a vertical.
An area of 150 mm from the sides, top and bottom of the case should be kept clear.
Cooling is provided by forced ventilation on certain models. The installer must make the
necessary arrangements to ensure that the temperature of the air at entry is less than 40°C in
extreme operating conditions.
Arrangements must also be made to ensure hot air can get away either side of the charger
and in superior part.
CDTV DEA Page 17