Connecting Antenna(E) - Loewe DVB-T Mode D'emploi

Connecting antenna(e)

Connect the antenna cable from the roof antenna to the antenna socket
"IN VHF/UHF/DVB-T" on the back of your TV set to receive digitally/
terrestrially broadcast stations.
An indoor antenna can also be used under good reception conditions.
Passive and active room antennas are offered commercially. In an active
antenna its power is supplied via the antenna connection
"VHF/UHF/DVB-T".
The supply voltage (5 Volt) must be correspondingly set in the
„TV Menu – Connections–– DVB antenna–– DVB-T antenna".
Slot for
Common-Interface-
Module (CI)
4
DVB_T_S_GB_F_Esp
Euro-AV- Euro-AV-
socket 2
socket 1
4
It is advisable to use an antenna without directional characteristic. If the
location is outside the normal transmission range, a directional antenna
(Yagi) can also be used to improve the reception quality.
You can obtain more detailed information about receivable digital stations
in your area from your dealer.
You can also receive an analogue cable station or an analogue terrestrial
station and a satellite station at the same time and watch with the picture
in picture (PIP) function.
Satellite-antenna socket
Digital sound output
Antenna socket VHF/UHF/Cable/DVB-T
18.11.2004, 13:51 Uhr
Switch
on/off
Socket for power cable
Depending on the type of set
Can be retrofitted