Cleaning
Turn the running gear to the back with
your foot.
Turn the program selection switch to the
desired cleaning program.
Set the water quantity according to the
degree of dirt accumulation and the floor
covering.
Lower the squeegee tool.
Turn on the brushes by pulling the con-
trol handle.
Warning!
Risk of damage to the floor covering. Do not
operate the machine on the spot.
Shutting down and parking the ma-
chine
Turn the water quantity control button to
the closed position.
Drive the machine forwards for another
1-2 m to draw off residual water.
Turn the program selection switch to
"OFF".
Raise the squeegee tool.
Turn the running gear to the front with
your foot.
Disconnect the main plug.
Warning!
Risk of deformation of brushes – when par-
king the machine, relieve the pressure on
the brushes by turning the running gear to
the front
Emptying the Dirty Water Reservoir
Note
If the dirty water reservoir is full the float clo-
ses the suction channel. The suction opera-
tion is interrupted. Empty the dirty water
reservoir.
Warning
Please observe the local regulations regar-
ding the wastewater treatment.
Take the dirty water drain hose from the
support and lower above a suited collec-
tion device.
10
English
Drain water by drain hose cover remo-
ving.
The rinse the dirty water reservoir with
clear water.
Emptying the fresh water tank
Release the coupling at the upper end of
the fill level display.
Lower the hose for the fill level display
into a suitable collector and drain off li-
quid.
Engage the coupling on the machine
again.
Transport
If you want to transport the machine on a
vehicle secure it from slipping.
To reduce the required space the push
handle can be turned to the front:
Release the star grips of the push handle
fastening.
Turn the push handle to the front.
Maintenance and care
Danger
Risk of injury. Turn the program selection
switch to "OFF" and disconnect the mains
plug before performing any work on the ma-
chine.
Drain and dispose of dirty water and ex-
cess fresh water.