Pkupdate - Promax DT-802 Mode D'emploi

CONTROL MODULE. DT-802
- Save All Modules.
It saves all changes made and validated of all the modules. After entering,
press ENTER
ATTENTION!
If you do not save these changes will be lost when you turn off the control
module!
- About.
It is an information option. It shows technical information of all the modules, as the
firmware version or the IPN (Identifier Product Number). Press ENTER and then left or
right to see information of all the modules.

4.8.2 PkUpdate

The program PkUpdate allows you to update the firmware your headend DTTV.
In the case of new versions of firmware, you will need this program PkUpdate to
transfer the update file from your computer to the DTTV microprocessor.
Steps to follow:
1.- Install the software PkUpdate on your computer. Double-click on the
executable located in the folder "PkUpdate" which is in the CD supplied
with the unit DT-802.
2.- Once installed, run the program from the icon
has been created on the desktop. Previously, make sure the computer is
connected to the module DT-802.
3.- Click on the shortcut icon "Load Update configuration file"
through the browser window that opens, find the updating file that you
should have been previously downloaded.
4.- Click on the updating file and press "Open."
5.- Use the key "MODEL"
DT-802 module. If it does not comunícate then check the communication
parameters by pressing the setup key
network is working properly.
04-2015
to confirm you want to save your changes.
in order the program detects the
PkUpdate.lnk
PkUpdate that
and
. Check also the cable
Page 27