Dt-802 Configuration - Promax DT-802 Mode D'emploi

3.- To move between characters press the RIGHT
delete a character do a long press (1 s) by pressing RIGHT
LEFT
4.- To change a character press the UP
type of character (uppercase and lowercase letters, symbols or
numbers) make a long press (1 s) with the UP
key.
5.- When you are finished editing press ENTER
and exit the menu.
WARNING!
To VALIDAT E a value after changing it you must press ENTER
If you press ESCAPE
For the changes were applied, you must SAVE previously the settings. There are
tw o different ways to save the settings made:
On one hand you can save your settings
O n the other hand you can save the settings of all modules at once using the
SAVE ALL option, which is on the DT-802 menu.
4

.7.4 DT-802 Configuration

The DT-802 is the control
m odule of the DTTV. The DT-802 controls the DTTV headend. Two wire-bus connect
the c ontrol module to the remaining modules of the headend. The DT-802 allows the
control and configuration of each module in a separate way.
Page 22
.
the value will not be accepted.
and power module, and therefore is the most important
CONTROL MODULE. DT-802
or DOWN
using the SAVE option on each module.
or LEFT . To
or
. To vary the
or DOWN
to validate the text
or UP .
04-2015