Main Screen - Promax DT-802 Mode D'emploi

The scanning process takes about ten seconds. After it, it displays on the screen
a list of all the modules identified. If the process takes longer, maybe there is a problem
with the wiring or the CPU.

4.5 Main Screen

The main screen shows the list of all the modules identified.
At the top of the screen the text MODULES FOUND indicates the number of
modules detected and below a list with the names of each one of the modules.
If the modules detected are more than four, the list is rotating, that is, it rotates on
a sequential order to show all the elements.
The modules are identified as follows:
DT-XXX-SY-MZ
Where:
XXX
SY
MZ
The bottom of the screen shows the current STATUS of the modules. If
everything is correct it shows the message "OK. PRESS ENTER TO SETUP" (Fig. 9).
Page 16
Indicates the name of the module.
S means SLOT and Y is a number equal to the slot position in the
subrack case. This position is the one the module assigns
automatically every time you turn it on. If it does not correspond to
the actual position can be changed manually, but it does not affect
the operation for practical purposes.
M means MODULE and Z is a number that identifies the receiver or
modulator module (1 for the first module, 2 for the second one).
Figure 9.- Main Screen.
CONTROL MODULE. DT-802
04-2015