Varma Tec VARMA 301 IPX5 Mode D'emploi page 10

ENGLISH
IS
according to the instructions given in this booklet. Star Progetti cannot
assume any responsibility for damage to property or personal injury
resulting from failure to abide by the instructions given in this booklet.
 Use a multi-polar switch with minimum contact gaps of 3 mm when
installing the appliance.
 Connect the appliance to the electrical power supply only if the
system is able to provide the maximum electrical voltage and capacity
indicated on the rating plate at maximum power.
 Before carrying out any type of cleaning or maintenance operation,
turn the appliance off and turn the main power switch off to
disconnect it from the power supply.
 Should the appliance be dropped or suffer a heavy blow, have it
checked immediately by Star Progetti.
 When carrying out maintenance operations, never touch the bulbs
directly, but only the terminal casings. The bulb will be damaged by
contact with naked hands; in this eventuality the product guarantee
will no longer be considered valid.
 In the event of accidental contact with the surface of the bulb, clean
it immediately by wiping with a cloth dipped in denatured alcohol.
 If the appliance does not function correctly or develops a fault, turn
it off and contact Star Progetti immediately.
 Ensure that only genuine original Star Progetti spares are used for
any repairs. If the cable or the power plug are damaged, take the
appliance to an authorised Star Progetti service centre for
replacement. Use a cable with T180 characteristics.
 Switch off the appliance at the main switch: a) if the appliance does
not function correctly; b) before cleaning the outside of the appliance;
c) if the appliance is not to be used for long periods of time.
 Do not cover or block the appliance during use.
 In order to avoid creating a fire hazard, the appliance must never be
installed with the radiating elements close to or facing towards
curtains, beds or other objects or materials that are liable to burn
easily; always ensure that these objects are at a suitable minimum
distance, to avoid any risk of fire or heat damage.
 Never use the appliance in combination with programming devices,
timers or other devices that will switch it on and off automatically.
 When the connection is made directly to the main electric net:
You need to provide a device to ensure the all-pole disconnection from
the electric net with a opening distance from the contacts, allowing a
complete disconnection in the conditions of overvoltage category III,
in accordance with the installation instructions.
10