Cleaning - Black & Decker SMARTSELECT BDPH400 Mode D'emploi

• To get an even spray distribution, always keep your arm at the
same distance (figure I) from the surface you are spraying and
avoid moving your wrist (figure J).
• Maintain smooth and consistent speed which will help avoid
inconsistencies. Begin spraying after the pass has begun and
release trigger before stopping the pass.
• Avoid spraying too heavily in any one area. Several lighter coats
are better than one heavy coat which can lead to running and
dripping. Remember that the flow control knob regulates the
amount of liquid that can be sprayed. Turning the flow knob
clockwise increases the flow of liquid. Turning the knob
counterclockwise decreases the flow of liquid. If runs or drips do
occur, have a dry paint brush on hand to smooth them out.
• Turn the power unit off and place the sprayer in the built-in dock
of the power unit when not spraying for any length of time.
WARNING:
• Do not use materials with a flashpoint higher than 60°C ( 140°F) . Flashpoint is the temperature that a fluid can
Be sure to use appropriate protective gear.
produce enough vapors to ignite (see coating supplier).
• Make sure clean up area is well ventilated and free of flammable vapors.
• Always spray outdoors when spraying cleaning solution through sprayer.
• Do not submerse power unit.
• Use drop cloths during pouring, mixing, and viscosity testing of materials to be sprayed to protect your floors and
anything else in the spraying area that you wish to remain untouched.
To begin cleaning:
• Turn the power unit off, unplug the cord and
disconnect air hose from sprayer.
• Unscrew the lid from the side of the canister
and pour any remaining liquid back into the
original container (figure K).
• Pour a small amount of the appropriate
cleaning solution into the canister (figure L).
• Warm soapy water for water based
materials
• Manufacturers recommended cleaning
solution for oil based materials
• Replace the lid on the canister securely and
vigorously shake the sprayer.
• Unscrew the lid from the side of the canister
and properly dispose of cleaning solution.
• Refill the canister with a small amount of new
cleaning solution (figure L). Screw lid securely
on canister.
• Reattach the air hose to the sprayer, plug in
the cord and turn on the power unit.
• Spray the cleaning solution through the
sprayer onto scrap material for 2 to 3 seconds
(figure M).
• Turn the power unit off, unplug the cord and
disconnect air hose from sprayer.
• Remove the canister and unscrew the side lid.
Remove the check valve, pickup tube and o-ring
from the sprayer. Clean the parts with the
cleaning brush in the appropriate cleaning
solution (figure N).
J

CLEANING

K
M
9
L
N