Maintenance; Storage; Accessories - Black & Decker SMARTSELECT BDPH400 Mode D'emploi

• Unscrew the tip collar and remove the spray
nozzle and spray tip. Clean all parts with the
cleaning brush in the appropriate cleaning
solution (figure O).
• If using water based material, clean the
sprayer by running water through pickup tube
inlet as shown in figure P. If using oil based
materials, clean pickup tube inlet with the
appropriate cleaning solution. Repeat until
sprayer is completely clean.
• Dry all parts throughly.
• Properly dispose of cleaning solution.
• Place a drop of household oil onto the metal
ball in the check valve (figure Q).
IMPORTANT: Lubricating the ball in check valve, after cleanup, will help to prevent it from sticking which can
clog the valve and prevent adequate flow of spray material.
NOTE: When reassembling, place metal ball end of check valve into sprayer.
Q
• Reassemble sprayer (figure R). NOTE: The spray tip can only go in one way. The notch on the spray tip,
shown in figure S must align with the recess in the threads of the sprayer.
Use only mild soap and damp cloth to clean the power unit. Never let any liquid get inside the power unit; never
immerse any part of the power unit into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized service centers or other qualified service organizations, always
using identical replacement parts.
The power unit contains a washable/reuseable filter
(figure T). Check the filter before and after each use. If
dirty, wash with warm water and allow to air dry before
re-installing or replace if necessary.
• To check the filter, remove the filter cover by pressing
in on the sides of the filter cover and pulling the cover
off the power unit. Remove the filter as shown in
figure T and inspect. Replace filter and filter cover.
Never operate the power unit without the filter in place.
Debris could be sucked in and interfere with the
function of the power unit.
Make sure unit is clean and dry before storing. Store unit indoors in a dry location. To prevent damage, wrap the
electrical cord so that it is not crimped during storage.
Recommended accessories for use with your product are available from your local dealer or authorized service
center. If you need assistance regarding accessories, please call: 1-800-544-6986
WARNING: The use of any accessory not recommended for use with this product could be hazardous.
O
R

MAINTENANCE

T

STORAGE

ACCESSORIES

10
P
S