Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
and steel nose is compulsory.

Use

Clean the area of all foreign items before use. Stone, glass, branches, etc. can damage the
tiller. Check that all bolts on the tiller are tightened.
Start:
Place the throttle handle on choker/full throttle.
Follow the guide in the user manual to start.
Stop:
Place the throttle handle on minimum throttle.
Follow the guide in the user manual to stop.
The black handle is used to move the tiller forwards. The red handle is used to move the tiller
backwards. If your back is against an obstacle, pay extra attention when reversing, for
example a tree or a wall.
The rotors drive the tiller forward. The rotary speed is regulated by the throttle control. If the
tiller is held back, the rotors dig downwards into the ground.
If the tiller has a tendency to dig down, there are several things you can do. The right and left
blade set can be changed. This means that the tiller will use the reverse of the blade to till,
and thus it will not be so easy to dig down. In addition, side guards can be fitted. This also
helps prevent the tiller from digging down.
The depth skid must always be placed in the top notch if this is the case. See also the section
on adjusting the depth skid.
In addition to the speed of the engine, the speed is controlled by the depth skid, which is
placed behind the machine.
Do not cultivate in very wet soil as clods of soil will be formed, and these are difficult to break.
Dry and hard soil may need to be cultivated twice.
The outer blades can be dismounted if the tiller is used between narrow rows of plants and
crops. This reduces the tilling width.
The ground can be tilled in two directions, thus achieving optimum tilling.
Figure 12.
When the engine is running, do not pull the handle for forward speed and the handle for rear
speed at the same time! This will damage the transmission. Always release one handle
before the other is used. Always wait until the blades have stopped rotating before another
handle is activated.
It is important, that you do not try to hold back the tiller. It must be relaxing to use the
machine.
Do not overload your tiller. Always drive carefully.
12

Publicité

Table des Matières
loading

Table des Matières