AKO 52044 Mode D'emploi page 23

Control of relays
You can activate or deactivate the output relays at will, by sending SMS messages, which allows you to remotely
act on the facility.
To change the status of the relays, send "RELES, <Relay 1 status>, <Relay 2 status>".
Relay statuses:
Example: To activate relay 1 and deactivate relay 2, send:
After a few seconds, the alarm responds with the message*:
RELE 1: ON
RELE 2: OFF
Power failure alert message
If a power failure occurs, the alarm starts to operate in battery mode and sends an alarm message with the same
sending sequence as the other alarms (see page 22).
ALARM, AC, "texto definido por el usuario"
To confirm receipt, send:
When power is restored, the alarm will send a new alarm message which does not require confirmation.
NO ALARM, AC, "texto definido por el usuario"
The alert message is customisable in both cases (see pg. 21).
Reset alert
If the unit is restarted, whether it is because of a power failure or a forced restart using
the reset button, the alarm sends a customised message (see pg. 21) to the first
telephone number on the list. If you have not customised the message, the alert will not
be sent.
Reset function
The alarm has two types of reset:
-Partial reset. Press the reset button for less than 5 seconds: the alarm is
reset and it keeps the current configuration.
-Total reset. Press the reset button for more than 5 seconds: the alarm is
reset and returns to the factory settings, including the password. (All of the LEDs turn on and off 3 times).
*If you receive an error message, refer to page 26.
0 OFF 1
23
ON
RELES,1,0
OK AC
5204H401 Ed.04
SEND
ENVIAR