Installation - AKO 52044 Mode D'emploi

5.- Installation

Fig. 1a
4 8 m m
Figure 2
2
2
1
IMPORTANT: Before starting to install the alarm, check that there is enough coverage in the installation
place.
Any manipulation of the SIM card should be done with the power supply and the battery
disconnected.
-Open the SIM card cover at the back of the unit and install the SIM card (Fig. 2). Remember that the PIN must
be disabled.
-Assemble the supplied antenna (figura 3).
-Remove the connections cover (C) and the main cover (A) by inserting a screwdriver into each of the 4 slots and
turning it by 90º (figures 1a and 1b).
-Connect the battery (Figure 4) and check that the coverage LED lights up green after a few seconds.
-Mark and drill the 2 fastening holes of the box on wall according to Figure 1.
-Close the main cover (A).
-Affix the alarm to the wall using two screws (B) and 2 plugs (not included).
-Make the wiring connections according to the diagram on page 18. The terminal strips can be detached to make
wiring easier (Figure 5).
-Close the cover (C).
Figure 1
Figure 3
3
1
18
A
Fig. 1b
B
C
Figure 4
5204H401 Ed.04
Figure 5