Assembly And Commissioning; Use - Glatz FORTELLO Notice De Montage Et D'utilisation

Assembly and commissioning

1
2
2.1 2.3
2.2
3
4
Unpack the shade
Supplied with:
- shade, bottom pole, tie-rope, top, top disc
- battery pack incl. charger
- operating instructions
!
Dispose of packaging materials properly
and keep away from children.
Do not install defective material.
In case of damage, please inform the
transport service provider immediately.
Pre-assemble parasol
1. At the top end of the pole, first put top
disc in place and then screw top on.
2. Establish plug connection. Take care to
observe the polarity of the plug.
3. Insert bottom pole into top pole and tight-
en screws.
!
Lay the power cable in such a way that it is
free of tension. Ensure that the connection
of the lower and upper pole is secure.
Make sure that cable is not pinched.
Prepare the floor fastening
Place the floor fastening in accordance
with the separate instructions.
Size Base weight Wind speed*
[m] [kg] [km/h (Bft.)]
ø 4.0 > 120 < 85 (9)
4.0 x 3.0 > 120 < 85 (9)
3.0 x 3.0 > 120 < 100 (10)
3.5 x 3.5 > 120 < 85 (9)
4.0 x 4.0 > 180 < 75 (8)
* maximal wind speed with fixed ground anchorage
Setting up the shade
Fix shade in the base.
28 29

Use

Adjust the light
1
Open sunshade
1. Remove any protective cover
2. Release binding belt
3. Open parasol with the help of the slide
4. Pull down the tensioning lever and
hook it in place
5. Lock the tensioning lever in the down
position
!
Make sure that the clamping lever is
closed
2
Insert battery
1. Slide battery pack onto adapter plate
2. Press the battery pack down firmly
!
Ensure that you have a functional
electrical connection.
3
Adjusting the light
Tap when OFF:
1x recommended brightness
2x maximum brightness
Checking the
Tap when ON:
charge status
1x switch off
2x maximum brightness
Tap and hold when ON:
when bright reduce brightness
empty
when dark increase brightness
fully
!
Direction changes with each tap
charged
and hold.
4
Close shade
1. Remove the battery pack and store
it in a dry place. Charge if necessary.
2. Release clamping lever, close shade.
3. Pull out / wrap fabric segments
4. Apply binding belt
5. Apply protective cover if necessary
!
Only wrap / pack completely dry
parasols.