Bushnell PRIME TRAIL CAMERA Mode D'emploi page 26

distances.
c.Please note that when the Capture Number parameter is
set higher than "1 Photo", or with very short Interval settings, some images may
appear darker than others due to the quick response and rapid retriggering of the
camera, allowing less time for the flash to fully recharge before firing again.
Daytime photos or videos appear too dark
2.
a.Make sure that the camera is not aimed at the sun or
other light sources during the day, as this may cause the auto exposure to produce
darker results.
Night photos or videos appear too bright
3.
a.You will get the best results when the subject is within the ideal flash range, no
closer than 10' (3m) from the camera. Subjects may appear too light at closer
distances.
b.Change the Interval setting from 1S to 3S or higher. The camera will be in auto
exposure mode to avoid "whiteout" photos.
Daytime photos or videos appear too bright
4.
a.Make sure that the light sensor will not be in the shade (from tree
leaves/branches) while the camera lens is aimed into a bright area.
Photos with streaked subject
5.
In some cases with low lighting conditions and fast moving subjects, the 12MP
a.
or 24MP resolution settings may not perform as well as the 3MP setting.
If you have multiple images where fast moving subjects produce streaks on the
b.
photo, try the 3MP setting instead.
c.Change the Interval setting from 1S to 3S or higher to minimize motion blur.
6.Red, green or blue color cast
a.Under certain lighting conditions, the sensor can become confused resulting in
poor color images.
b.If this is seen on a consistent basis, then the sensor may need servicing. Please
contact Bushnell customer service.
7.Short video clips—not recording to the length set
a.Check to make sure that the SD card is not full.
b.Make sure that the camera has good batteries in it. Near the end of the battery
life, the camera may choose to record shorter video clips to conserve power.
Date/Time Stamp not appearing on images
Make sure that the "Time Stamp" parameter is set to "On".
26