Wedge (Monitoring) Installation; Wall-Mounting With Brackets; Installation On Truss With Brackets And Aliscaff Couplers; Installation With Eyebolts - dBTechnologies OPERA 10 Mode D'emploi

WEDGE (MONITORING) INSTALLATION

In some cases the OPERA series speakers can be used as monitors for small live
contests. In this case, lay them horizontally on the tilted side. Be reminded of the
sound coverage features reported in the relevant section. Use the suitable DSP
settings as indicated in the "DSP preset" table in wedge mode (W1, W2, or FLAT).

WALL-MOUNTING WITH BRACKETS

The OPERA models can be wall-mounted in vertical or horizontal position through
the WB-OP10, WB-OP12, WB-OP15 accessory, to be used with OPERA10, OPERA12,
OPERA15, respectively.
For further details refer to the instructions relevant to this accessory.

INSTALLATION ON TRUSS WITH BRACKETS AND ALISCAFF COUPLERS

The OPERA models can be installed on a truss in vertical or horizontal position,
through the WB-OP10, WB-OP12, WB-OP15 accessory, to be used with OPERA10,
OPERA12, OPERA15, respectively. This accessory allows the use of aliscaff couplers
(not included) for this special configuration.
For further details refer to the instructions relevant to this accessory.

INSTALLATION WITH EYEBOLTS

Is it possible to install the speaker using eyebolts.
Positioning is represented in the opposite figure,
in which the rear eyebolt allows to adjust the final
angle (MAX 45°).
OPERA10 OPERA12 OPERA 15
30
English
COD. 420120247 REV. 1.1