ROSIERES COMBI Mode D'emploi page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To deactivate Smart Eco: Click "option" until it goes
to Smart ECO, click "OK" to quit this function and the
light goes off.
FAST COOLING: Activate Fast Cooling mode to start
an additional pulse for a fast freezing of the fridge
compartment. The function is activated and
confirmed by the switching on of the dedicated LED
icon.
To enter Fast Cooling: Click "option" until it flickers
in "Fast Cooling" and then click "OK" to enter this
function.
To deactivate Fast Cooling: Click "option" until it goes
to "fast cooling" and then click "OK" to deactivate
this function.
FAST FREEZING: Activate Fast Freezing to rapidly
freeze big quantities of food keeping intact
nutritional food properties. When the light in Fast
Freezing goes off and the freezer temperature goes
back to the value before fast freezing. When Fast
Freezing time is up (26 hours), it deactivates
automatically. When it goes to Vacation, Fast
Freezing stops.
To enter Fast Freezing: Click "option" until it flickers
in "Fast Freezing" and then click "OK" to enter this
function.
To deactivate Fast Freezing: Click "option" until it
goes to "fast freezing" and then click "OK" to quit
this function.
VACATION: In case of long stops, the Vacation
function can be used. This function deactivates the
fridge compartment, while leaving the freezer on.
Ensure that there is no food inside the fridge
compartment before using this function. The
function is activated and confirmed by the switching
on of the dedicated LED icon. The light in Vacation
goes off and the refrigerator temperature goes back
to the value before Vacation.
Vacation quits under functions of Smart ECO and Fast
Cooling.
To enter Vacation: Click "option" until it flickers in
"Fast Freezing" and then click "OK" to enter this
function.
To deactivate Vacation: Click "option" until it goes to
"Vacation" and then click "OK" to quit this function.
POWER OFF MEMORY: Refrigerator can
automatically keep all the setting in case of power off.
When the unit is plugged in again, the refrigerator
will run with the setting before power off.
POWER-ON DELAY: To prevent harm to the
refrigerator in case of sudden power cut and power
on, the unit does not start immediately if the power
off time is less than 5 minutes.
FREEZER OVER-TEMPERATURE ALARM (only in case
of power on): When the freezer temperature is
higher than 10°Cat the first time connected to
power, the symbol light of the freezer chamber goes
on and the number representing temperature
flickers.
Press any button or wait for 5 seconds, flickering
stops and it goes back to the temperature that was
set.
REFRIGERATOR DOOR OPENING ALARM: When the
refrigerator is open over 3 minutes, the buzzer will
buzz. Close the door or press any button to stop the
alarm, but for the latter, the alarm will go off again
after 3 minutes.
SENSOR FAULT ALARM: When it shows "E0", "E1",
"E2" or other abnormal symbols, it means sensor
faults and the refrigerator needs repair.
TECHNICAL FEATURES
FRESHNESS CONTROL (if present)
Thanks to freshness control,
you can guarantee the right
humidity level for vegetables
and fruits in the crisper
drawer (Fresh drawer). The
humidity gets bigger as the
rod goes from left to right.
WATER DISPENSER (if present)
The water dispenser allows you to get chilled water
without opening the fridge compartment door.
Before first use
cover and then clean the water tank and cover
in warm soapy water. Rinse thoroughly.
- After cleaning, attach the cover to the water tank
and then replace
the water tank back on the fridge door.
- Clean the dispenser pad outside the fridge door.
Filling the water tank with water
- Open the small cover.
- Fill the water tank with drinkable water up to the
Max line.
- Close the small cover.
Dispensing
To dispense water, push the dispenser pad gently,
using
a glass or container. To stop the flow of water, pull
your glass away from the
dispenser pad.
Tips for keeping food perfect in the
Fridge
Take extra care with meat and fish: cooked meats
should always be stored on a shelf above raw meats
to avoid bacterial transfer. Keep raw meats on a
plate which is large enough to collect juices and
cover it with cling film or foil.
Leave space around food: this allows cold air to
circulate around the Fridge, ensuring all parts of the
Fridge are kept cool.
Before using the water
dispenser for the first time,
remove and clean
the water tank located
inside the fridge
compartment.
- Lift the water tank out of
the fridge compartment.
- Open the water tank
19

Publicité

Table des Matières
loading

Table des Matières