Publicité
Les langues disponibles
Les langues disponibles
- To prevent damage and injuries, keep the
operating appliance (with or without
attachment) away from scalp hair, eyebrows,
eyelashes, clothes etc.
- Charge, use and store the appliance between
10°C and 35°C.
- If your appliance is equipped with a light for
optimal use, do not look directly into the
light.
- Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive liquids
to clean the appliance.
Electromagnetic fields (EMF)
- This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
General
- This appliance is waterproof (Fig. 3). It is suitable for use in the bath or
shower and for cleaning under the tap. For safety reasons, the appliance
can therefore only be used without cord.
- The supply unit is suitable for mains voltages ranging from 100 to 240
volts.
- The supply unit transforms 100-240 volts to a safe low voltage of less
than 24 volts.
Charging
Note: Charge the appliance fully before you use it for the first time.
Note: This appliance can only be used without cord (Fig. 4).
To charge the appliance, insert the small plug into the socket in the bottom
of the appliance and put the supply unit in the wall socket.
- The charge indicator flashes white (Fig. 5): the appliance is charging.
Charging takes up to 1.5 hours.
- The charge indicator lights up white continuously (Fig. 6): the appliance
is fully charged and has a cordless operating time up to 40 minutes.
- The charge indicator does not light up when the appliance is switched
on: the appliance contains enough energy to be used.
- The battery indicator flashes orange (Fig. 5): the battery is almost empty
and needs to be charged. Charge the appliance when you have finished
using it.
Note: If the appliance is fully charged but still connected to the wall socket,
the battery indicator flashes a few times when you press the on/off button.
This indicates that you should disconnect the appliance from the wall
socket before you can switch it on.
Quick charge
- When the battery is completely empty and you start charging it, the
battery indicator flashes white quickly.
- After approximately 15 minutes, the battery indicator starts flashing white
slowly. At this point, the battery contains enough energy for up to 10
minutes of use.
Using the appliance
Attaching and detaching the attachment
1
To attach the attachment, press it onto the handle ('click') (Fig. 7).
2 To detach the attachment, press the release button on the back of the
appliance (Fig. 8).
Attaching and detaching the callus removal disk
1
To attach the disk, push it onto the coupling in the head (Fig. 9).
Look at the appliance from the side to check if the disk is level with the
outer rim of the head.
If the disk wobbles when you switch on the appliance, the disk is not
placed correctly. Remove the disk and attach it properly.
2 To remove the disk, put your thumb in the indent behind the disk and
push it forward until the disk detaches from the head (Fig. 10).
Switching the appliance on and off
1
To switch on the appliance, press the on/off button once.
2 If you want to select the low speed setting, press the on/off button
again.
3 To switch off the appliance, press the on/off button once more.
Use areas
Note: This appliance is only intended to be used on the feet.
You can use the callus removal disk in 3 different ways, depending on the
area or callus you want to treat.
1
To treat a large, flat area, use the entire disk (Fig. 11). Make sure you
place the disk flat onto the skin for good control during use.
2 For precision treatment of smaller areas and good visibility of the treated
area (Fig. 12), use the top part of the disk that sticks out beyond the top
of the head (Fig. 13).
3 For precision treatment and for buffing away hard skin very quickly, use
the narrow edge of the protruding top part of the disk (Fig. 14).
Move the disk back and forth gently over the skin you want to treat. Do not
push too hard. When you push too hard, the disk might stop rotating.
Cleaning
- Clean the callus removal disk with the cleaning brush supplied (Fig. 15).
Remove the disk and clean the inside and outside of the head with the
cleaning brush (Fig. 16).
- If you prefer, you can rinse the callus removal disk and the inside of the
callus removal head under a running tap (Fig. 17). You can clean the
appliance with a moist cloth (Fig. 18).
Tip: You can also clean the callus removal disk and the inside of the callus
removal head with disinfectant now and then.
Storage
If you travel, disconnect the callus removal head from the appliance. This
protects the abrasive disk and also prevents the immediate surroundings
from being damaged by the abrasive disk.
Replacement
Replace the callus removal disk when its effectiveness decreases. We
advise you to replace the disk at least once every year (BCR372).
To buy accessories or spare parts, visit www.shop.philips.com/service or go
to your Philips dealer. You can also contact the Philips Consumer Care
Center in your country (see the international warranty leaflet for contact
details).
Warranty and support
If you need information or support, please visit www.philips.com/support
or read the international warranty leaflet.
Warranty restrictions
Parts that are subject to normal wear (such as cutting units and callus
removal disks) are not covered by the international warranty.
Recycling
- This symbol means that this product shall not be disposed of with
normal household waste (2012/19/EU) (Fig. 19).
- This symbol means that this product contains a built-in rechargeable
battery which shall not be disposed of with normal household waste
(Fig. 20) (2006/66/EC). We strongly advise you to take your product to
an official collection point or a Philips service center to have a
professional remove the rechargeable battery.
- Follow your country's rules for the separate collection of electrical and
electronic products and rechargeable batteries. Correct disposal helps
prevent negative consequences for the environment and human health.
Removing the rechargeable battery
Only remove the rechargeable battery when you discard the product.
Before you remove the battery, make sure that the product is
disconnected from the wall socket and that the battery is completely
empty.
Take any necessary safety precautions when you handle tools to
open the product and when you dispose of the rechargeable battery.
1
Remove the back and/or front panel of the appliance with a screwdriver.
Remove any screws and/or parts until you see the printed circuit board
with the rechargeable battery.
2 Remove the rechargeable battery.
Deutsch
Einführung
Herzlichen Glückwunsch zu Ihrem Kauf und willkommen bei Philips! Um die
Unterstützung von Philips optimal nutzen zu können, sollten Sie Ihr Produkt
unter www.philips.com/welcome registrieren.
Allgemeine Beschreibung (Abb. 1)
1
Hornhautentfernungs-Scheibe
2 Äußerer Rand
3 Hornhautentfernungs-Aufsatz
4 Griff
5 Ein-/Ausschalter
6 Akkuanzeige
7 Buchse für Gerätestecker
8 Entriegelungstaste
9 Stromversorgungseinheit
10 Reinigungsbürste
Wichtige Sicherheitsinformationen
Lesen Sie diese wichtigen Informationen vor dem Gebrauch des Geräts und
des Zubehörs aufmerksam durch, und bewahren Sie sie für eine spätere
Publicité
