Monacor img StageLine TWIST-1LED Mode D'emploi page 16

between 001 and 502 to indicate the start
address set.
2) Press the button ENTER.
appear on the display.
3) Press the button ENTER again. Display:
(address).
4) Press the button ENTER again: The start
address will start flashing and can now be
set with the buttons UP and DOWN.
Press the button ENTER to confirm.
The display will briefly show
and will then return to
5) Press the button DOWN once to return to
the display
Press the button ENTER. The display
will show the number of DMX channels
set. Set the number desired (5, 9 or 11 CH)
with the button UP or DOWN.
6) Save the setting with the button ENTER, or
discard it with the button MENU.
7) To set additional functions, refer to the
table below (fig. 11). To show the start
address again, press the button MENU
twice.
8) Set the same start address and the same
number of channels for all additional units
TWIST-1LED that are to be synchronously
controlled.
9) The moving head can now be controlled by
DMX. The DMX functions can be found in
chapter 3.2.3 (fig. 12). If the TWIST-1LED
does not receive any DMX control signals,
the start address will start flashing.
16
(DMX) will
.
(channels).
Overview of all setting options
for the DMX mode
Menu
Setting Function
item
...
(save)
⑪
Setting options for the DMX mode
After selecting a menu item, press ENTER. Use
UP or DOWN to select the setting, and use
ENTER to save it.
...
DMX start address
number of DMX channels
behaviour of the unit when no
DMX control signals are received
LED off, moving head will go to
the centre position
"freeze" of the most recent
control command
show program run
music-controlled program run
display will show:
start address
DMX values, see chapter 3.2.4
= factory settings