Fan Speed Control - Ebac 2000 Série Mode D'emploi

Fan speed control

Adjusting the fan speed
You may wish to change the fan speed of your Ebac from time to time. Using the Full Fan Speed
Control Panel(4) will remove more moisture from the air compared to the Low/Quiet Control Panel(3)
thereby improving efficiency. When switched on, your dehumidifier will default to fan speed setting A.
Pressing the Full Fan speed button(4) will scroll through the settings below.
Setting Function
Low/Quiet setting - fan illuminated in green moving at low speed(7)
A
Normal setting - fan illuminated in green moving at high speed(7)
B
Continuous Fan Mode Quiet - fan illuminated in amber moving at low speed(7)
C
Continuous Fan Mode Normal - fan illuminated in amber moving at high speed(7)
D
The speed of the fan is indicated by the green fan symbol - the higher the setting the faster this
symbol rotates.
Standby: When selected, the dehumidifier will not extract water. Pressing Low Fan Speed(3)
will instruct the unit to go into Standby Mode. Depending on the current fan speed, you may need
to press this several times until Standby Mode is indicated by the power -on light turning
amber(8). By pressing the Full Fan Speed Button(4) the unit will return to fan speed setting A.
Air Cleaning (Continuous Fan Mode): When fitted with one of our high performance filters, your
dehumidifier may also be used as an air cleaner. To do this, press the Full Fan Speed(4) until the
fan symbol(7) turns amber. Pressing the Full Fan speed(4) again will increase the Fan speed for
faster air filtration.
Max Continuous/8 hour Run(2): The Max Continuous/8 hour run(2) on your Dehumidifier allows
the setting of Smart Control and fan speed to be overridden maximising water extraction from
the air. This is ideal for laundry drying etc.
To use this function select max(2) on your dehumidifier (refer to relevant control diagram) until
MAX(6) illuminates on the control panel, then select normal setting (fan speed B) on your
dehumidifier. The unit will now run on maximum fan speed continuously until standby or Smart
is reselected.
Pressing the max(2) button again will cause the MAX(6) symbol to flash. The unit will now run on
maximum fan speed continuously for a period of 8 hours. After this time the unit will return to
the settings you had prior to activation.
62
GB