Depth Adjustment - Dremel Saw-Max 20 Consignes De Fonctionnement/Sécurité

DM 2610025602 01-13_DM 2610025602 05-12.qxp 1/22/13 10:29 AM Page 12
"LOCK-ON" BUTTON
The "Lock-ON" feature, incorporated into the
paddle switch, is a convenience for long
operations.
TO LOCK SWITCH "ON": After paddle switch
has been activated push "Lock-ON" button at
rear of tool completely in and release paddle
switch (Fig. 7).
TO SWITCH TOOL "OFF": Squeeze and
release paddle switch (Fig. 7).
In order to try to avoid recoil (a situation where
the wheel wants to skip out of the material) it
is recommended to make cuts in the same
direction as the rotation of the wheel.
It is important to read and
W RNING
understand the section in
this manual called "Kickback and Related
Warnings".

DEPTH ADJUSTMENT

Disconnect plug from power source. Loosen
the depth adjustment lever located on the right
side of the tool. The foot is spring loaded and
will lower automatically (Fig. 8).
Tighten lever counter clockwise at the depth
setting desired. Check desired depth (Fig. 8).
LINE GUIDE
The cutting guide notch will give an
approximate line of cut (Fig. 9). Make sample
cuts in scrap lumber to verify actual line of cut.
FIG. 7
P DDLE
SWITCH
DEPTH SC LE
LINE GUIDE
-12-
"LOCK-ON"
BUTTON
"LOCK-OFF"
SWITCH
RELE SE LEVER
DEPTH
DJUSTMENT
LEVER
FIG. 8
FIG. 9