Bimar FS40 Notice D'instructions page 9

Fax +32 030 9904733
Stand
1. Cross the two feet (7) and attach them to the fixed pole (11) with the 4 screws provided with nut.
2. Unscrew the fixed pole ring nut (5) and slide if off; insert the cover (10) to cover the junctions
between the feet and the fixed pole.
3. Lengthen the adjustable pole (9) until the height desired and lock it by tightening the pole
attachment ring nut.
Fan
4. Insert the rear grille (16) in the motor housing, so that the handle (17) appears at
the top (as figure),and position it so that the pins fit in their corresponding holes
and lock it with the ring nut provided (15).
5. Insert the fan (14) on the motor shaft (1), so that the slot matches the spline.
Lock using the ring nut (13), (turning it counterclockwise to tighten).
6. Couple the front grille (12) to the rear one (16) locking it with the closing hooks.
For safety reasons, you must make sure that it is attached by using the screws
and nuts provided, which are to be used in the holes in the edge of the grilles
(the holes for the screw must be in the lower part).
7. Attach the fan body to the stand by inserting the lower hole on the adjustable
pole of the stand and lock it by tightening the stand attachment screw (4).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
9 24
/
Assembly page 9/24
1) Motor shaft
2) Oscillation button
3) Body
4) Body attachment screw
5) Pole attachment ring nut
6) Feet attachment screw
7) Foot
8) Selector
9) Adjustable pole
10) Cover
11) Fixed pole
12) Front grille
13) Fan attachment ring nut
14) Fan
15) Grille attachment ring nut
16) Rear grille
17) Handle