Bimar FS40 Notice D'instructions page 8

Fax +32 030 9904733
D
•
o not use the device at room temperatures above 40 °C.
D
•
o not move the appliance when it is in function.
D
•
o not leave the device exposed to the weather (sun, rain, etc.).
• D
o not pull on the cord to disconnect the plug from the socket.
I
•
f the supply cord is damaged, it must be replaced by the manufactuer, its service agent or similarly
qualified persons in order to avoid a hazard.
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not use
it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails,
etc.) must be kept out the reach of children because they are potential sources of danger. Attention:
any stickers or advertising material applied to the grid removed before using the appliance. The
manufacturer declines all responsibility in case this is not safe working practices will be respected.
• Before connecting the appliance, check that the voltage values shown on the data plate (220-240V~
50Hz) correspond to those of the electricity supply network. In the event of incompatibility between
the electric outlet and the plug of the appliance, have the outlet replaced with another more suitable
type by professionally qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the heater. In general, the use of adapters or extension
cords is not recommended; if their use is indispensable, they must conform to existing safety standards
and their current capacity (amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters) to
avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
•
T
he appliance must not be used in dusty environments or in the presence of extremely volatile
materials which could obstruct grid or of inflammable products.
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help: repairs made by unqualified persons can be dangerous and render void the warranty.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
If in doubt, have the appliance checked or assembled by a qualified professional person. For assembly,
refer to figure.
Attention: the fan can be used only when completely and correctly assembled, that is complete with its
base and protection grid.
Attention: always unplug the appliance before you assemble.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
8 24
/
Assembly page 8/24