glass 1989 SAUNE Notice D'utilisation page 53

correspond to a low temperature.
Humidity
The humidity can be set from 10% to 80%.
To go to the programming mode, press
the and buttons until the word
with the ''MENU/OK'' button. The display
shows a message saying "CLIMATE_SET"
"Humidity_50%" or the last message set.
Set the humidity with the
(e.g. 65%).
press the "MENU/OK" button
and after a few seconds the display will
_OFF" "Humidity _current humidity".
The humidity is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
ATTENTION: If the vaporizer is empty,
an acoustic warning signal is emitted and
this message appears on the display:
"CLIMATE _ON" "Vaporizer_empty" and
the vaporizer turns off at the same time.
Top up with water.
ATTENTION: Follow the operating
i n s t r u c t i o n s p r o v i d e d b y t h e
manufacturer of the vaporizer.
Press the "MENU/OK" button to turn off
the acoustic signal.
FAN
(not supplied with the sauna)
If there is a fan installed in the sauna, it
can be connected to the control unit and
controlled by the command mentioned
above.
The fan speed can be set from 0 (off) to
100%.
NOTE: If there is no fan installed: select
0% = OFF
To go to the programming mode, press
the and buttons until the word ''Fan''
''MENU/OK'' button. The display shows
"CLIMATE_SET" "Fan_60%" or the value
previously entered.
Set the desired temperature with the
and
Press the ''MENU/OK''
message saying ''CLIMATE_OFF'' ''Fan_
OFF'' appears on the display.
The fan status is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
and buttons
programming.
Turning the automatic mode on / off
The automatic mode can be activated after
the programming stage.
Press the
word "Automatic
selection with the ''MENU/OK'' button.
The display will show a message saying
"CLIMATE_SEND" "Automatic_ON" and
after a few seconds the confirmation
message "CLIMATE_AUTO" appears,
switching to the ''Start-Time_18:30''
parameter.
The automatic mode is on. The system
starts heating at the set time.
To turn off the automatic mode, press
the
"Automatic" appears. Confirm the
selection with the ''MENU/OK'' button.
The display will show a message saying
"CLIMATE_SEND" "Automatic_OFF"
message "CLIMATE_OFF" "Automatic_
OFF" appears.
The automatic mode is off.
When the sauna turns off, an acoustic
signal is emitted and the display shows
a message saying "CLIMATE_OFF" and
''Duration_STOP'' appears in the session
duration parameter.
Moreover, the sauna drying program
starts automatically (fan not supplied).
NOTE: the drying program is not carried
21
buttons (e.g. 80%).
and button until the
and button until the the word
EN