glass 1989 SAUNE Notice D'utilisation page 43

SESSION DURATION
The remaining operation time is shown
on the lower line of the display.
After having set the temperature, press
the "MENU" key to set the SESSION
DURATION.
Set the desired value using keys
(between min. 1h and Max. 6h) within
10 seconds (LED
"MENU" key, or wait for the value to be
stored automatically after 5 seconds.
PROGRAMMED SWITCH-ON
To set the desired switch-on time, press
the "MENU" key twice. On the display the
LED
By pressing key
maximum pre-set operation time of
6:00h, one switches to PROGRAMMED
SWITCH-ON, indicated on the display by
the icons (A) in the picture below:
One can now set the desired programmed
switch-on time.
Set the desired value using keys
and Min 10 minutes with 10-minute
increments) within 10 seconds (LED
and the symbol (A) stay on, making
the count-down start.
The lower line of the display (B) shows
the count-down relating to the remaining
pre-set time. When this value reaches
zero, the stove switches on automatically.
NOTE: the programmed switch-on
time set does NOT remain stored the
next time the display is switched on.
LIGHT
By pressing key
sauna light on and off.
The light is independent from other
functions.
NOTE: See lamp assembly instructions for
and
until exceeding the
one can switch the
the characteristics of the bulb to be used.
FAN
(not supplied with the sauna)
If there is a fan installed in the sauna, it
can be connected to the control unit and
controlled by the command mentioned
above.
By pressing the button
the fan on and off. The fan is independent
from other functions.
11
EN
one can switch