glass 1989 SAUNE Notice D'utilisation page 52

duration parameter.
The programmed values are saved in the
control device until the next time they are
edited.
OPERATION IN BIOSAUNA MODE
EN
Select the function by pressing the
button.
MANUAL START
Set the duration of the session, see the
"Session duration" chapter.
Then press the ''START/STOP'' button to
start the sauna with the last values set.
The display shows a message saying
"CLIMATE_ON" "Duration_2:30".
To end the session before the set time,
press the "START/STOP" button again.
PROGRAMMED START
Setting when the heating starts
You can set what time the sauna turns on
from 00:00 to 24:00 hours.
To go to the programming mode, press
the and
"Start-Time" appears.
OK'' button. The display shows a
message saying "CLIMATE _SET" "Start-
Time_00:00" or the last message set.
Set the desired value with the
buttons (e.g. 18:30).
Press the ''MENU/OK''
message saying "CLIMATE _OFF" "Start-
Time_18:30".
The start time is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
Session duration
You can set a heating session lasting up
to 6 hours.
To go to the programming mode, press the
and buttons until the word ''Duration''
buttons until the message
and
''MENU/OK'' button. The display shows
a message saying "CLIMATE _SET"
"Duration_00:00" or the last message set.
Set the desired duration of the session with
the and buttons (e.g. 2:30).
Press the ''MENU/OK''
message saying "CLIMATE _OFF"
"Duration_STOP" appears on the display.
The duration of the session is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
The sauna drying program starts
automatically at the end of the session
(fan not supplied).
NOTE: the drying program is not carried
out if the function is interrupted before the
set duration of the session.
Sauna temperature
The heating temperature can be set from
10°C to 80°C.
To go to the programming mode, press the
and buttons until the ''Temperature''
with the ''MENU/OK'' button. The display
shows a message saying '"CLIMATE
_SET" "Temperature_50°C" or the last
message set.
Set the desired temperature with the
and buttons (e.g. 40°C).
P r e s s t h e ' ' M E N U / O K ' ' b u t t o n t o
confirm and after a few seconds a
_OFF" "Temperature_actual temperature"
appears on the display.
The temperature is set.
NOTE: if the settings do not change within
20 seconds, you will automatically exit the
programming.
ATTENTION: In the CLIMA mode, the
TEMPERATURE and HUMIDITY values
are interrelated.
A high temperature will correspond to
low humidity and high humidity will
20