Menu Operations - JVC KD-X250BT Manuel D'instructions

Menu operations

Menu operations
1
(Hold)
If no operation is done for about 60 seconds, the
operation will be canceled.
2
Menu item
DEMO
EQ PRESET
EASY EQ
PRO EQ
FADER *1*2
BALANCE *2
BASS BOOST
LOUD
(Loudness)
VOL ADJUST
(Volume adjust)
L/O MODE
(Line output
mode)
SUB. W *3
(Subwoofer)
SUB.W LPF *4
(Subwoofer low-
pass filter)
SUB.W LEVEL *4
(Subwoofer level)
*1 If you are using a two-speaker system, set the fader level to "00".
*2 This adjustment will not affect the subwoofer output.
*3 Displayed only when <L/O MODE> is set to <SUB.W>.
*4 Displayed only when <SUB.W> is set to <ON>.
20 | ENGLISH
Selectable setting (Initial: [XX])
For settings, page 4.
For settings, page 19.
R06 — F06 [00]: Adjusts the front and rear speaker output balance.
L06 — R06 [00]: Adjusts the left and right speaker output balance.
+01/+02: Select your preferred bass boost level.
[OFF]: Cancels.
[LOW]/HIGH: Boosts low or high frequencies to produce a well-balanced
sound at a low volume level.
OFF: Cancels.
-05 — +05 [00]: Presets the volume adjustment level of each source,
compared to the FM volume level. Before adjustment, select the source you
want to adjust. ("VOL ADJ FIX" appears if "FM" is selected.)
Select if the REAR/SW terminals are used for connecting the speakers or
subwoofer (through an external amplifier).
SUB.W: Subwoofer
[REAR]: Rear speakers
OFF: Cancels.
[ON]: Turns on the subwoofer output.
[THROUGH]: All signals are sent to the subwoofer.
LOW 55Hz/MID 85Hz/HIGH 120Hz: Audio signals with frequencies lower
than 55 Hz/85 Hz/120 Hz are sent to the subwoofer.
-08 — +08 [00]: Adjusts the subwoofer output level.
3 Repeat step 2 if necessary.
To return to the previous menu, press
To exit from the menu, press DISP or MENU.
.