Cub Cadet Snow Cab/Sun Shade Manuel De L'utilisateur page 7

8. Assemble the canopy prior to attaching
it to the top of the frame. Insert the
cross supports (Ref. part #3) into the side
supports (Ref. part #7). Then attach the
center rod (Ref. part #4) in the mounting
holes located on the front and rear
cross supports. Then assemble the cross
support rods (Ref. part #4) with rod
connectors (Ref. part #4) and place the
ends into the mounting holes located on
the inside of the side supports.
Figure 3-7
9. Wrap the velcro around the center rod
and cross support rods.
10. Finally attach the top side supports to
the rear side supports and the front side
supports.
Installing the Sun Shade
NOTE: If you purchased the Snow Cab Kit
(19A30022100) alone, the Sun Shade attachment
(790-00710) can be ordered separately.
1. Slide the sun shade over the top of the
frame with the long mesh flap towards
the back.
2. There are four tie-down straps on the
outside corners of the sun shade; two in the
front and two in the back. Secure the front
and back of the sun shade with these straps
as shown in Figure 3-8.
Figure 3-8
3. There are two straps on the rear mesh
flap of the sun shade. Wrap these around
the rear supports and secure as shown in
Figure 3-9.
Figure 3-9
Installing the Snow Cab
NOTE: If you purchased the Sun Shade kit (Part
#19A30021100) alone, you can order the Snow
Cab attachment (790-00712) separately.
NOTE: To help remove any wrinkles in the snow
cab, leave the snow cab unfolded out in the
sun.
1. Unfold the snow cab and lay it over the top
of the frame. Make sure that the silver/gray
reflector along the upper rear of the back
window is facing towards the rear of the
tractor. See Figure 3-10.
Figure 3-10
2. Remove the backing tape on the reflector
labels and install the labels on the outside
of the cab as shown in Figure 3-11.
Figure 3-11
3. There are five clips around the base of
the snow cab, three on the back and one
each on the left and right side.
4. The rear center clip clips onto the center
of the fender. See Figure 3-12.
Figure 3-12
5. The outer rear clips clip onto the fenders
near the wheels. See Figure 3-13.
Figure 3-13
S 3 — A & S
ection SSembly
-U 7
et p