Unify OpenStage PhoneAdapter Notice De Montage page 10

Installation
Installation
Prerequisite: One operational OpenStage T system telephone.
The PhoneAdapter is installed between the phone and the connection cable.
This is a front view of the PhoneAdapter:
a/b
Analog
output socket
1. Connect the power supply unit to the power source and plug the other end into the
socket in the PhoneAdapter.
2. Place your OpenStage phone on a soft surface with the keyboard facing downwards.
3. Remove the cable from the
on the PhoneAdapter.
4. Using the supplied cable, connect the
0 Master output socket" on the PhoneAdapter. 
"U
p
Your phone is now operational again.
5. Push the "Analog/U
or to the left if you want to attach an analog terminal.
6. Now connect the additional device as follows using the second cable supplied.
Connection of an additional U
Using the supplied cable, connect the
cket" on the PhoneAdapter
or
Connection of an analog terminal:
Connect the terminal to the "Analog output socket" on the PhoneAdapter. Use a cable suitable
for the analog device. Only cables with a suitable western jack (e. g. not TAE) can be used. You
may be able to use the cable supplied with the PhoneAdapter, see "Characteristics of the a/b
interface"  Seite 11.
You must connect an OpenStage phone to the "U
to operate devices on the "U
10
u
p
Switch
analog/Up0 Slave
Up0 Slave
output socket
socket on your phone and plug it into the "u
0 Slave" switch to the right if you want to connect a further U
p
0 system telephone:
p
0 Slave" and "Analog" output sockets.
p
0 u 0 u
p
Up0 Master
output socket
Up0
input socket
socket on your OpenStage phone to the 
socket on the telephone to the "U
0 Master" socket in order to be able
p
Q
0
p
Power supply
unit
0 input socket"
p
0 Slave output so-
p
Q
0 phone
p